I just bought a set of their 1.5 inch risers, they are good quality parts, and well constructed.:thumbup: They were easy to install and definately give a better riding position.
I did have to make a couple of modifications to them, one was I had to drill the holes for the switch housings and also drill a hole so I could mount the front brake fluid container. The other mod I did was not neccessary, however I cut about 1 inch off of the handle itself so it would be the same length of the stock clipon handle and not stick out too far.
I know some of the people on here had asked about clipon risers, so if anyone has any questions about these particular ones let me know.
redbeep
06-12-2009, 03:38 PM
Since you have purchased the risers, do you find that it helps you sit in a more comfortable riding position? I spoke to the Swatt folks and they said that the risers only go up and not back. I was wondering if that would help me, as I was thinking about ordering the 2.5" risers. These are certainly alot cheaper than the Convertibars! My hands get tingly when I lean on the bars and was hoping the Swatt bars would help that. Any info would be appreciated.
Thanx - Paul
It deffinately helps make the riding position more comfortable:thumbup:. I used to have the same problem with my hands and wrists going numb. Now I can ride on long trips and not have any problems.
dsmitty37
06-12-2009, 10:16 PM
could you post a picture?
could you post a picture?
Give me a day or two and I'll post one.
It's hard to get a good picture of them, so I just took one from the side.
http://i22.photobucket.com/albums/b324/brandon627/DSCF1152.jpg
uglyryder
03-12-2010, 06:04 PM
i think this is something id like to look into but i tried to search for swatt and there web site wont load. did you get yours direct from swatt?