Suzuki GSXR Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all!!!!

I am completely new to the forum, and have a old 85/86 preslingshot engine in a K model sling shot frame, its a bit of a street fighter.... :hmmm:

It has the Mikuni Vm29SS flatslide carbs and the following problems:

Idles just ok and nice and low but I can't rev the bike at all or it dies.
Before I cleaned the carbs the revs would stick and hang. My accelerator pump doesn't squirt fuel through the A/P Nozzles.

My setup:
EMGO Individual cone filters
Needle - 6DP3 (on 4th clip at the moment)
Main jet - 125
Needlejet - P-5
Pilot jet - 20

Air fuel screws turned 1 and a half turns out. Any ideas on what could be the problem? too rich or so lean? as far as i can see the aren't any vacuum leaks?

HELP please i wana ride her again!!!!:headscrat

Thanks in advance!
 

·
Registered
Joined
·
8 Posts
Im new on here as well, also with a fairly old gsxr (1992). The best tip I got was to go to the service manuals sticky and see if your bike is in there. Sorry I couldnt offer anything else, good luck!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top