Suzuki GSXR Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Has anyone had this problem? So I adjusted my air screws on my 08 1000 as my exhaust was white and had no power plus bogging down at 6k rpm I have tried everything I've found on forums to get some guts back into her I've changed pumps stripped and cleaned throttle bodies flushed and cleaned injectors eliminated all emmission shit including blanking out the idle speed control sensor. To no avail it still bogs runs better with every change but still not getting anything out of her. But this is a wtf now running hard can get 10k rpm sometimes but still sticks at the 6k when warm. My question as I'm about to go buy vacuum guages and balance the throttle bodies is my aircrews started approx 1and 1/2 turns out I wound in marked them and went out 2and 1/2 turns. Where have I gone wrong? And does anyone have a solution for this loss of power and rpm I'm at my wits end
 

·
Administrator
Joined
·
11,243 Posts
Welcome to the forum.

With all this work, have you ever done a fuel pressure and volume check as per the service manual?
 

·
Registered
Joined
·
5,099 Posts
08 1000, and air screws? Aren't those on a carburetor?

What John said.
 
1 - 6 of 6 Posts
Top