Suzuki GSXR Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
ok, before anyone jumps me and says i should have searched, i did, some. my problem is, i am putting a bike, 06 GSXR1000 back together from painting it and the customer is on his way, in around an hour, and NOW the F1 is flashing in the temp location......F1...99(degrees)....F1.....100.....F1...etc, etc. it wasnt doing this before we took it apart. the front turn signals arent flashing either. when you turn the signal on, both will flash, but not flas, flash, barely pulse. like there is a bad ground somewhere. but we didnt disconnect any grounds. i just dont have a lot of time to figure this out, any ideas. thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top